From the message archive at
www.satforums.com

From: Nova Scotia -(HACKSRUS) TO: ALL
Date Posted: 201999-6-11 10:30:00
Message:
Body:
Seem that I've lost my volume/mute function and I can't get it back....Tried the receiver setting A3 and 003 on the remote.
I had to remove the battery to reset my remote because the red led was flashing for some unknown reason...this gave me control of the remote again but, I feel I trashed my remote setting.
Thanks again
Best Wishes From Nova Scotia
Canada's Ocean Playground!
 

From: Pat.. -(PATREILLY) TO: Nova Scotia
Date Posted: 201999-6-11 11:00:00
Message:
Body:
Volume Control Information:

One of the newest features added to the 4DTV IRD is the
ability for the remote control to operate the source volume of
the receiver via UHF and Infrared (IR). If your TV does not
have remote control of volume, or if you would like to be able
to control the volume of the receiver from other locations in
your home, for whole house audio applications for instance,
you can "program" that function into the remote control.
The 3-in-1 remote is programmed at the factory to control the
volume of your TV. To reprogram the remote control to operate
the source volume of the IRD press and hold the 4DTV button
at the top of the remote until the LED light begins to flash. The
key in 1-0-0. You will see the light stop flashing. The volume
function of the remote control will now bring up a volume
"bar" on the on-screen display of the receiver and allow you to
control volume via UHF and IR.

========================================

Multiple 4DTV UHF Frequencies

If you have more than one 4DTV receiver you may want to
prevent the remote controls from affecting the other receivers.
This may also be important if your neighbor has a 4DTV. To
prevent this kind of interference you must "pair" each remote
control with one receiver. In order to do this you will have to
assign a new "address" to each pair of remote controls and
receivers so that each pair functions independently of the
others.

To assign a unique "address" to a pair of remote controls and
receivers:

Press the POWER key on the receivers front panel to turn
it on.

Press the 5 key and the u key on the front of the receiver at
the same time. The receiver will display two figures: first
an "A," then a second number from 0 to 3. All together, it
looks like this: "A 0." The second figure is also known as
the "address" to which we referred earlier.

Press the 5 or 6 keys on the receiver’s Front Panel to
change the address to 0, 1, 2, or 3.

Press the ENTER key on the front panel to memorize the
change. Failure to do this will cause the receiver to reset
to the factory mode of "A 0" the next time the power is
cycled.

Press the POWER key to exit this mode

On the remote control that you plan to use with the
receiver, press and hold down the 4DTV key for about
three seconds until the LED flashes.

On the remote control, enter the numbers "00" and the
third number (the address) that you already have entered
on the Front Panel of the receiver (either 1, 2, or 3). If the
remote control accepts the new address, the LED will
flash rapidly several times. The four possible address
combinations are "000," "001," 002’" and "003."

If you are using the volume function to control the source
volume of the 4DTV receiver the codes should begin with
the number "1." The four possible codes for source
volume control are "100," "101," 102," and "103."